Samsung TS-H292A manual Rear

Introduction

Connecting the Cables

Rear

1.Digital output terminal

You can connect a sound card or MPEG card which support Digital output terminal to your drive using this two-pin terminal.

2.Sound output terminal

You can connect a sound card to your drive using this four-pin terminal.

This function is not covered in detail in this guide. Refer to the documentation supplied with your sound card.

3.Master/slave select terminal

Usually, this is a pre-set configuration as illustrated below.

Verify that the setting is as illustrated. If it is not, simply remove the jumper and place it in the correct position.

4.Interface terminal

This input/output interface terminal is used to connect the 40-pin flat cable from the IDE interface to the CD-R/RW drive.

5.Power terminal

The power terminal is a four-conductor male plug. (A : +5V DC)

(B : +12V DC)