Samsung TS-H292A manual Installing a jumper on the master/slave select terminal

Setup

Connecting the Cables

Installing a jumper on the master/slave select terminal

Connect a jumper to the rear side of the CD-R/RW.

If the jumper is connected to MA (Master), it will work in the Master mode. If the jumper is connected to SL (Slave), it will work in the Slave mode.

If the jumper is connected to CS (CSEL), you can control the device by using the host interface signal CSEL. (In general, connection to MA is recommended.)

Connecting the audio cable from a sound card

Connect the 4-pin audio cable between the sound output terminal on the CD-R/RW drive and the audio input terminal on the sound card.

For clearer sound, use a digital output terminal.(Available only for the CARD that supports digital output) This may not be available for general sound cards.