Samsung TX-S2040X manual Connecting VHF and UHF Antennas, Antennas with 300-ohm Flat Twin Leads

Chapter Two

I N S TA L L AT I O N

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like this, see “Antennas with 300-ohm Flat Twin Leads” below.

If your antenna has one lead that looks like this, see “Antennas with 75-ohm Round Leads” on the next page.

If you have two antennas, see “Separate VHF and

UHF Antennas” on the next page.

Antennas with 300-ohm Flat Twin Leads

If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow the directions below.

1

Place the wires from the twin leads under the screws on the 300-75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws.

2

Plug the adaptor into the “VHF/UHF” terminal on the rear panel.

English - 11