Cooling Your Room
You must select the Cool mode if you wish to adjust the:
◆Cooling temperature
◆Fan speed when cooling
1 If necessary, press the 
(On/Off) button.
Result: ◆ The air conditioner starts up in Cool mode with
Turbo fan speed.
◆ The operation indicator on the indoor unit lights up. ◆ The indoor unit beeps.
IMPORTANT The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being:
◆Plugged in
◆Stopped
lt will start up normally after three minutes.
2 If the 
is not displayed at the top of the remote control,
press the 
button on the remote control one or more times until it appears.
Result: ◆ The indoor unit beeps each time you press the 
button. ◆ The air conditioner runs in COOL mode.
Note You can change modes at any time.
3 To adjust the temperature, press the 
button one or more times until the required temperature is displayed.
Possible temperatures are between 18°C and 30°C inclusive.
Result: ◆ Each time you press the 
button:
-The temperature is adjusted by 1°C
-The indoor unit beeps
◆The air conditioner starts cooling, provided that the room
temperature is higher than the selected temperature.
◆If the room temperature reaches the set temperature, the air
conditioner stops cooling, but the fan is still operating.
4 Select the fan speed by pressing the 
button one or more times until the required setting is displayed:
Automatic (rotated : 
)
Low
Medium
High
Turbo (maximum)
Result: Each time you press the 
button, the indoor unit beeps.
5 To control the direction of the air flow, refer to page 15.
Note ◆ If you turn off the air conditioner in Cool mode, the set temperature is adjusted as below when you turn on the air conditioner again.
Previous set temperature | Set temperature |
Over 24°C | 24°C |
Below 24°C | Previous set temperature |
|
|
