Samsung VCU2911S4R/ADH Maintenance, Emptying the Dirt Cup, Cleaning the Pre/Post-motor Filter

Maintenance

Familiarize yourself with these home maintenance tasks as proper use and care of your cleaner will ensure contin- ued cleaning effectiveness.

When to empty the Dirt Cup

The dirt cup needs to be emptied when the dirt reaches the "Full" line on the side of the Cup. If more dirt than this accumulates, your cleaner will not operate effectively.

Note: All new carpet has loose fibers which can fill the Dirt Cup quickly while vacuuming.

Emptying the Dirt Cup

Disconnect cleaner from electrical outlet.

3-1	Full Line
Unlock	Lock
Position	Position

3-2

3-3

Slide the Cyclone-Lever to the "Unlock" position.

Grasp handle and pull the Dirt Cup straight out to remove from Vacuum.

Empty dirt into garbage container. Put the Dirt Cup back in the vacuum and slide the lever to the "Lock" position.

Cleaning The Circular Filters.

Grasp the Filter Cup located at

the bottom of the Dirt Cup and twist counterclockwise to unlock and remove.

Cleaning the Pre/Post-motor Filter

3-4

Pre-Motor

Filter

How to clean

Disconnect cleaner from electrical outlet.

The Pre-Motor Filter protects the Motor from debris.

It is located underneath the Dirt Cup and Filter Cup in the Center of the round part of the Cyclone-Lever.

Remove the small round Filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

3-5

Post-Motor

Filter

The Post-Motor Filter assists in the filtation process to return clean air to the room. It is located behind the door on the front of the Cleaner. When the filter becomes dirty, open the door, remove the filter and shake the dust off the filter.The Post- Motor Filter is non-washable therefore do not wash it in water.

Replace the door by inserting the tabs on the left side and snapping the right side into place.

Do not operate cleaner without Either the Pre-Motor Filter or Post-Motor Filter in place.

3-6

Grasp the Circular Filters and twist to unlock Pull straight up to remove. Separate the Outer foam and Inner pleated Circular Filters.

Wash each individually by hand

in warm water. Mild detergent may be used if desired. Rinse well, then air dry Thoroughly dry before putting them back together and replacing in the Filter Cup The Filter Cup may be washed In warm water with a mild detergent. Make sure it is completely dry before reassembling with fliters.

4