basic recording

SEARCHING QUICKLY FOR A DESIRED SCENE (SETTING THE ZERO MEMORY)  (VP-D382( i )/D382H/D385( i ) only)

•The zero memory function works in both Camera and Player modes. ➥page 18

•You can mark a point on a tape that you want to return to following playback.

1.Set the Select switch to TAPE. (VP-D385( i ) only)

2.Press the MODE button to set Camera ( ) or Player ( ).

3.Press the ZERO MEMORY button on the remote control before the recording or during playback at the point where you wish to return.

•The time code is changed to a tape counter that is set to zero memory with the zero memory ( 0:00:00 ) indicator displayed.

•If you want to cancel the zero memory function, press the ZERO MEMORY button again.

4.Finding the zero position.

•When you have finished playback, fast forward or rewind the tape in stop mode. The tape stops automatically when it reaches the zero position.

•When you have finished recording, press the MODE button to set Player ( ) and press the (REW) button.

The tape stops automatically when it reaches the zero position.

5.The tape counter with the zero memory ( ) indicator disappears from the display and the tape counter is changed to the time code.

•In the following situations, zero memory mode may be cancelled automatically:

-At the end of the section marked with the zero memory function.

-When the tape is ejected.

-When you remove the battery pack or power supply.

•The zero memory may not function correctly where there is a break between recordings on the tape.

•The zero memory function is available only using the remote control.

38_ English

CARD

TAPE

MODE

(VP-D385( i ) only)

STBY SP

0:00:30

16:9 Wide 10Sec

60min

 

S 16BIt

 

C.Nite 1/30