![](/images/new-backgrounds/1161689/16168921x1.webp)
Vacuum cleaning Robot may not be able to continue its
NOTE operation if it is stuck at the entrance or veranda doorsill.
- Vacuum cleaning Robot stops operating for safety reasons if it cannot move for more than 5 minutes.
- To resume operating, turn the Power Switch off and then on again after moving it to a location where it can continue cleaning.
| Vacuum cleaning Robot cannot completely clean locations |
NOTE | that it cannot reach, such as corners, and spaces between |
| sofas and walls. |
| - Please clean these locations occasionally. |
| Dust clusters may remain after cleaning, when the vacuum cleaning robot fails to |
NOTE | pick up dust clusters that were formed while cleaning. |
-In this case, sweep up the dust with another cleaning tool.
CLEANING AND MAINTENANCE
When cleaning the product, do not spray water directly onto CAUTION the exterior or wipe it with a volatile material such as benzene,
thinner or alcohol.
- This may result in critical damage to the product.
Do not forcefully press the bumper on the Vacuum cleaning
CAUTION Robot.
- If the bumper sensor gets damaged, the Vacuum cleaning Robot may bump into walls or furniture.
The unit must not be disassembled or reconstructed by anyone CAUTION other than a qualified service engineer.
- This may result in damage to the product.
01 SAFETY INFORMATION
Remove any foreign substances accumulated on the Obstacle WARNING and Cliff sensors on a regular basis.
-Dirt accumulated on the sensors will result in inaccurate functioning of the sensors.
Cliff sensor |
Obstacle sensor |
safety information _11