Vacuum cleaning Robot may not be able to continue itsNOTE operation if it is stuck at the entrance or veranda doorsill.

- Vacuum cleaning Robot stops operating for safety reasons if it cannot move for more than 5 minutes.

- To resume operating, turn the Power Switch off and then on again after moving it to a location where it can continue cleaning.

 

Vacuum cleaning Robot cannot completely clean locations

NOTE

that it cannot reach, such as corners, and spaces between

 

sofas and walls.

 

- Please clean these locations occasionally.

 

Dust clusters may remain after cleaning, when the vacuum cleaning robot fails to

NOTE

pick up dust clusters that were formed while cleaning.
-In this case, sweep up the dust with another cleaning tool.

CLEANING AND MAINTENANCE

When cleaning the product, do not spray water directly onto CAUTION the exterior or wipe it with a volatile material such as benzene,

thinner or alcohol.

- This may result in critical damage to the product.

Do not forcefully press the bumper on the Vacuum cleaning

CAUTION Robot.

- If the bumper sensor gets damaged, the Vacuum cleaning Robot may bump into walls or furniture.

The unit must not be disassembled or reconstructed by anyone CAUTION other than a qualified service engineer.

- This may result in damage to the product.
Remove any foreign substances accumulated on the Obstacle

Cliff sensor

WARNING and Cliff sensors on a regular basis.

 

- Dirt accumulated on the sensors will result in inaccurate functioning of the sensors.

Obstacle sensor

INFORMATION SAFETY 01

safety information _11