CONNECTING THE DRAIN HOSE | (a) |
| After pressing the joint ring(a), insert the drain hose(b) |
|
| to drain direction. |
|
| (b) |
HOW TO ADD THE FABRIC SOFTENER |
|
•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.
•Do not use detergent, bleach or starch into the Softener Inlet.•Using too much softener may produce unsatisfactory results.•Do not open the lid during the Spin Dry cycle.If added too early, its effectiveness will decrease.
•Do not leave the softener into the Softener
Dispenser for a long time. Because softner became stiff.
WATER SUPPLY CONNECTOR FILTER
| inlet water |
|
| valve |
|
| 1.Pull out the filter and wash well. | 2. Pull in the filter and connect | 3. Check if there is a leakage. |
| the hose to the inlet water | Note to tighten up the |
| valve tightly. | connector. |
CLEANING THE FILTER NET Clean the filter net often to keep the washer clean. 
1.Push the upper part of the filter and pull in.
| 2. Open the cover as | 3. Clean the filter. | 4. Close the cover and insert the |
| shown in the figure. |
| lower part of the filter in the |
|
| basket first and then push the |
|
| filter with "click" sound . |
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor. | (pump drained washer) | |
| 2. Rotate the filter counterclockwise | 1.Place a rag under washer filter not to wet the floor. | |
| and pull out the filter. | 2.Turn the | |
| 3. Remove dirts and rotate | 3.Take the filter out and | |
| the filter clockwise | remove dirts. | |
| until it locks in position. | 4. Reassemble in | |
| reverse order. | |
HOW TO ASSEMBLE THE LEGS | Hook | |
Hole | ||
| ||
| 1. Check the 4 | ||
| 2. Lay down the Washing Machine to the front. | 2 | |
1 | ||
| 3. Insert the hook of leg in to the square hole of base. | Base | |
| 4. Push the leg to the arrow direction to “Click”. |
| |
Screw
6