Samsung WA15G2Q1 LEVELLING, WATER SUPPLY CONNECTOR FILTER, Waterdrop mark, Adjustment of height, Cause, lower, lower, lower, lower, How to level, The back part is

LEVELLING ● If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.

●Adjust the height control legs to make eve.

Lock

Lock Nut

UNLOCK LOCK

Adjustable

Leg

Unlock

●After slightly lifting up the machine, rotate the adjustable leg counter-clockwise and pull as much as need to adjust the reight.

●After putting down the machine after adjustment.

UNLOCK LOCK

UNLOCK LOCK Lock Unlock

●Adjust the height and secure.●Secure the lock nut by rotating it firmly.●If the lock nut is not secured, the adjustable leg may be released.

Adjustment of height

If not leveled, adjust the legs to level the washer.●Be careful not to put in your hand under the legs. (It may cause some injury)Pull the handles located at the right and left of the front side and slide off.

Adjust the water drop mark to be in the red circle pulling back the machine slightly, and then, push it with a feet to fix.

Fix the handles by hand completely.

Waterdrop mark	Cause	How to level
	The front part is	Level it by adjustable legs.
	lower
	The back part is	Adjust the height by using the adjustable rubber
	lower	or prop at the back.
	The left part is	Adjust the left part by using the adjustable legs
	lower	at the front and the adjustable rubber at the back.
	The right part is	Adjust the right part of the washer by using the adjustable leg
		at the front and the adjustable rubber at the back.
	lower

WATER SUPPLY CONNECTOR FILTER

1.Pull out the filter and wash well.

inlet water valve

2.Pull in the filter and connect the hose to the inlet water valve tightly.

3.Check if there is a leakage. Note to tighten up the connector.

9