installation & maintenance
CAUTIONS WHEN INSERTING THE DRAIN HOSE
Less than 3 m
1.Don’t exceed more than 3 m when the 2. Be careful to drain water out at the end of
drain hose is used by connecting with | the drain hose. |
other hoses. |
|
Less than 3 m
Less than 5 cm
3.The doorsill shoudn’t be more than 5cm. 4. Don’t install the drain hose underneath the wash machine.
Test runMake sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.
CALIBRATION MODE
Your Samsung washing machine detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation. To run Calibration Mode, follow these steps:
1.Remove laundry or any contents in the machine.
2.Press the Delay End and Spin buttons simultaneously, and then press the Power button. The Machine turns on with “Cb”
3.Press the Start/Pause button to activate “Calibration Mode”.
4.The drum rotates for approximately 4 minutes.
5.When “Calibration Mode” is fi nished, “End” appears on the display, and the machine automatically turns off. The washing machine is now ready for use.
ADDING DETERGENT
1. Open the detergent drawer and then add the powder detergent into the detergent compartment.
2. Add detergent evenly so that it doesn’t brim over the
edge of the drawer.
• Use a reasonable amount of detergent. If you use more detergent than the standard
quantity or the water temperature is too low and the detergent does not dissolve in the water completely
causing it to remain on the laundry and in the hose and tub, it may cause damage such as dirtying and discoloring the laundry.
•If you use a powder detergent and it remains on the laundry, it may cause a bad odor. Rinse the laundry suffi ciently in fresh water.
If you spread a powder detergent over the laundry directly, it may result in discoloration. CAUTION Make sure to insert it into the detergent compartment.
If the water pressure is low, the detergent may remain in the detergent compartment.