Installing the Washing Machine
Selecting a location
Before you install the washing machine, select a location with the following characteristics:
•A hard, level surface (if the surface is uneven, see“Adjusting the leveling feet,” below)
•Away from direct sunlight.
•Adequate ventilation
•Room temperature that will not fall below 0 ˚C
•Away from sources of heat such as coal or gas
Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is installed on a carpeted floor.
Adjusting the leveling feet
If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under the feet):
1.Loosen the leg bolt by turning it with your hand until it is at the desired height.
2. Tighten the locking nut by turning it with a
If the washer is placed on an uneven or weak surface, noise or vibration occurs.
(Only a l degrees angle is allowed.)
Removing the shipping bolts
Before using the washing machine, you must remove the four shipping bolts from the back of the unit.
1.Loosen all bolts with the supplied wrench before removing them.
1.Loosen all the bolts with the supplied wrench.
2.Hold the bolt with the spanner and pull it through the wide section of the hole. Repeat for each bolt.
3.Fill the holes with the supplied plastic covers.
4.Store the shipping bolts away safely in case you have to move the washing machine in the future.
NOTICE Packaging materials can be dangerous to children; keep all packaging material (plastic bags, polystyrene, etc.) well out of the reach of children.
SAMSUNG Washing Machine Owner’s Instructions
