troubleshooting
fills with the wrong | • | Turn both faucets on fully. |
temperature water. | • Make sure the temperature selection is correct. | |
| ||
| • Make sure the hoses are connected to the correct faucets. | |
|
| Flush water lines. |
| • Check the water heater. It should be set to deliver a minimum 120° | |
|
| F (49° C) hot water at the tap. Also check the water heater capacity |
|
| and recovery rate. |
| • Disconnect the hoses and clean the screens. The hose filter screens | |
|
| may be plugged. |
| • As your Washer is filling, the water temperature may change as | |
|
| the automatic temperature control feature checks incoming water |
|
| temperature. This is normal. |
| • While your Washer is filling, you may notice just hot and/or just | |
|
| cold water going through the dispenser when cold or warm wash |
|
| temperatures are selected. This is a normal function of the automatic |
|
| temperature control feature as your Washer determines the |
|
| temperature of the water. |
door locked or will not | • | Press the Start/Pause Button to stop your Washer. |
open. | • Your Washer door will remain locked during the heating portion of the | |
| ||
|
| Sanitize Cycle |
| • It may take a few moments for the door lock mechanism to | |
|
| disengage. |
does not drain and/or spin. | • | Check the fuse or reset the circuit breaker. |
| • Straighten the drain hoses. Eliminate kinked hoses. If there is a drain | |
|
| restriction, call for service. |
| • Close the door and press the Start/Pause Button. For your safety, | |
|
| your Washer will not tumble or spin unless the door is closed. |
load is too wet at the end of | • | Use the High or Extra High spin speed. |
the cycle. | • Use high efficiency detergent to reduce | |
| ||
| • Load is too small. Very small loads (one or two items) may become | |
|
| unbalanced and not spin out completely. |
leaks water. | • | Make sure the door is firmly closed. |
| • Make sure all hose connections are tight. | |
| • Make sure the end of the drain hose is correctly inserted and secured | |
|
| to the drainage system. |
| • | Avoid overloading. |
| • Use high efficiency detergent to prevent | |
has excessive suds. | • | Use high efficiency detergent to prevent |
| • Reduce the detergent amount for soft water, small or lightly soiled | |
|
| loads. |
| • | |
|
|
|
|
| ||
|
| ||
|
|
|
|