Samsung WF80F5E3P4W/EE manual Powering your washing machine, Running Calibration Mode, Test run

STEP 5 - Powering your washing machine

Plug the power cord into a wall socket, an AC 220 - 240 V / 50 Hz approved electrical outlet protected by a fuse or circuit breaker. (For more information on the electrical and grounding requirements, refer to the “Electrical supply and grounding” section on page 12.)

Test run

Make sure that you install your washing machine correctly by running the Rinse+Spin cycle after the installation is complete.

STEP 6 - Running Calibration Mode

Your Samsung washing machine detects the weight of the laundry automatically. For a more accurate weight detection, it is recommended running Calibration Mode immediately after installing the washing machine. Follow the steps below to run Calibration Mode.

Before running Calibration Mode, make sure that there is nothing in the drum or on top of the washing machine.

1.Turn the washing machine off.

2.	Press the Power	button while holding down the Temp. and Delay End buttons simultaneously. The
	washing machine will turn on and "CLB" will appear on the display.
3.	Press the Start/Pause		button to start Calibration Mode.

4.The drum will rotate clockwise and counter-clockwise for about 3 minutes.

5.When Calibration Mode is complete, "End" (or “0”) appears on the display and the washing machine will turn off automatically.

6.The washing machine is now ready for use.

English - 18

Untitled-1 18

2015-07-28 ￿￿ 10:46:45