installation
Environment
•Leave some space.Space at last 15 cm between the washer and the wall.
•Place the washer on a sturdy flat surface. If the washer is placed on an uneven or weak surface, noise or vibration may be occured.
(Allowable is 2°)
•The washing machine shall not be inserted at a humid place.Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard.
•Avoid direct sunlight or heating devices. As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers,etc. Do not place under direct sunlight.
How to clean the filter (in case drain pump)
1.Place a rag under the washer filter not to wet the floor.
2.Rotate the filter counter clockwise and pull out the filter.
3.Remove dirts and rotate the filter clockwise until it locks in position.
Should be cleaned Filter at least 1 time a week.
Filter
Open 
CloseRag
Connecting the drain hose
Without pump: Insert the drain hose(a) and push it tighly to be connected as arrow direction.
With pump: Install the drain hose(A) about 70~80cm above the ground for pump model.
70~80cm
4_ installation
cleaning the machine
Cleaning the lint filter
If the dregs are filled up in the lint filter after finishing the wash, push down(1) and pull it out(2) as shown in figure.
Remove the collected lint and rinse the filter net.
Lint filter
Cleaning the wash tub
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.
Overflow filter
Pull the upper side of the overflow filter with 
two fingers into the hole ‘A’ in the direction of arrow as shown in the figure.
Cleaning the cover window spin
1.Rotate the cover window spin clockwise and pull out.
2.Cleaning the cover window spin.
3.Insert the cover window spin back and rotate it counterclockwise until locks in positon.
Close 
Open
Cover windows spin
Should be cleaned the cover window spin at least 1 time a month.
washing procedure
Washing
1.Before starting washing, check the following;
|
| ||
|
| ||
|
|
|
|