maintenance
Press the laundry evenly and put the safety cover into the spin basket drum as shown in the figure.
Bottom of balancer
Inner lid
Safety cover
Safety cover
For safety, pull the power supply plug out of the socket.
1.Disassemble a screws from the spin dryer hatch.
2.The spin dryer hatch is fixed to the brim by the concave and convex parts at two places. Expand the concave and convex parts, and pull up the spin dryer hatch to remove it.
3.Remove the clothing.
4.Close the spin dryer hatch. Push in hatch firmly until the catch at the front is engaged securely.
Spin dryer hatch
Screw
troubleshooting
| TROUBLE | CHECK POINT | |
The washer does not work. | Check that the power cord is connected to a power outlet well. | |
Power stoppage? | ||
| ||
|
| |
Clothes will not move freely. | Is the laundry overloaded? | |
|
| |
Incomplete spinning. | Are the laundry arranged evenly? | |
(Severe vibration or unbalance.) | ÂÂSee “When you load...” on page 7. | |
| In case no drain pump. | |
| - Be sure lay the drain hose down. | |
Water dose not drain. | In case drain pump. | |
| - Be sure remove the | |
| ÂÂSee “Before using...” on page 2. | |
| Is the spin dryer lid closed completely? | |
The spin dryer basket will not run. | Are laundry (socks,etc.) falling out of the spin dryer basket and clinging | |
to the axle? | ||
| ||
| ÂÂSee “ To pick out...” on page 7. |
In case no drain pump.
-Is the Cycle Selector set to drain?
-Is the drain hose clogged with scrap?
ÂÂHang up drain hose over the drain hose hook. Half fill the wash tub
The water drains out immediately. with the water and try for drain again. (Scrab will be removed by
water drain pressure.) In case drain pump.
-Is the drain hose hung about 70~80 cm above the ground? ÂÂSee “Connecting the drain...” on page 4.
maintenance _7
|
| ||
|
| ||
|
|
|
|