SanDisk 20-10-00038, Extreme III Table 3-20 Card Configurations

SanDisk CompactFlash Card OEM Product Manual Interface Description

3.4.2 Configuration Option Register (Address 200h in Attribute Memory) The Configuration Option Register is used to configure the card’s interface, address decoding and interrupt and to issue a soft reset to the CompactFlash Memory Card.

Operation D7 D6 D5 D4 D3 D2 D1 D0

R/W SRESET LevIREQ Conf5 Conf4 Conf3 Conf2 Conf1 Conf0

Bit

D7

D6

D5-D0

Name

SRESET

LevIREQ

Conf 5–Conf0

Description

Setting this bit to one (1), waiting the minimum reset width time and

returning to zero (0) places the card in the Reset state. Setting this bit to "1"

is equivalent to assertion of the +RESET signal except that the SRESET bit

is not cleared. Returning this bit to "0" leaves the card in the same un-

configured, Reset state as following power-up and hardware reset. This bit

is set to "0" by power-up and hardware reset. Using the PCMCIA Soft

Reset is considered a hard Reset by the ATA Commands. Contrast with

Soft Reset in the Device Control Register.

This bit is set to "1" when Level Mode Interrupt is selected, and"0" when

Pulse Mode is selected. Set to "0" by Reset.

Configuration Index. Set to "0" by reset. It's used to select operation mode

of the card as shown below. NOTE: Conf5 and Conf4 are reserved and

must be written as "0".

Table 3-20 Card Configurations

Conf5 Conf4 Conf3 Conf2 C onf1 Conf0 Disk Card Mode

0 0 0 0 0 0 Memory Mapped

0 0 0 0 0 1 I/O Mapped; any 16-byte system

decoded boundary

0 0 0 0 1 0 I/O Mapped; 1F0-1F7/3F6-3F7

0 0 0 0 1 1 I/O Mapped; 170-177/376-377

3.4.3 Card Configuration and Status Register (Address 202h in Attribute Memory) The Card Configuration and Status Register contain information about the card's condition.

Operation D7 D6 D5 D4 D3 D2 D1 D0

Read Changed SigChg IOis8 0 0 PwrDwn Int 0

Write 0 SigChg IOis8 0 0 PwrDwn 0 0

© 2007 SanDisk Corporation 3-23 Rev. 12.0, 02/07

Contents

Main SanDisk CompactFlash Memory Card OEM Product Manual Page Page Page Table of Content s Page 1.1 General Description 1.2 Features 1.3 Scope 1.4 CompactFlash Standard 1.5 PCMCIA Standard 1.6 Related Documentation 1.7 Functional Description Page Page Page 2.1 System Environmental Specifications 2.2 System Power Requirements Page 2.3 System Performance 2.4 System Reliability 2.5 Physical Specifications Page Page 3.1 Physical Description True IDE Mode Pin Assigments are contained in Table 3-3. Table 3-3 True IDE Mode Pin Assignments 3.2 Electrical Description Page Page Page Page 3.3 Electrical Specification Table 3-8 Output Drive Characteristics Figure 3-1 Power Up/Power Down Timing for Systems supporting RESET Figure 3-2 Power Up/Power Down Timing for Systems not supporting RESET Table 3-10 Common Memory Read Timing Specification signal. Table 3-11 Common and Attribute Memory Write Timing Specification signal. Table 3-12 Attribute Memory Read Timing Specification 3.3.7 Memory Timing Diagrams Figure 3-3 Common and Attribute Memory Read Timing Diagram Figure 3-4 Common and Attribute Memory Write Timing Diagram 3.3.8 I/O Read (Input) Timing Specification Figure 3-5 I/O Read Timing Diagram Table 3-13 contains the read input timing specifications. Table 3-13 I/O Read (Input) Timing Specification 3.3.9 I/O Write (Output) Timing Specification Figure 3-6 I/O Write Timing Diagram Figure 3-7 Register Transfer to/from Device Table 3-15 Register Transfer to/from Device The PIO data transfer parameters are defined in Table 3-16. signal. Table 3-16 PIO Data Transfer to/from Device 3.4 Card Configuration SanDisk CompactFlash Card OEM Product Manual Interface Description 2007 SanDisk Corporation 3-21 Rev. 12.0, 02/07 NOTE:The location of the card configuration registers should always be Interface Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 3-22 2007 SanDisk Corporation between consecutive cycle operaitons. Table 3-19 Attribute Memory Function Table 3-20 Card Configurations Card Configuration and Status Register (cont) 3.5 I/O Transfer Function 3.6 True IDE Mode I/O Transfer Function 4.1 I/O Primary and Secondary Address Configurations 4.2 Contiguous I/O Mapped Addressing 4.3 Memory Mapped Addressing 4.4 True IDE Mode Addressing 4.5 ATA Registers Page Page Page Page Card (Drive) Address Register (cont) Page 5.1 ATA Command Set Table 5-1 Primary and Secondary I/O Decoding Page Page Page Table 5-8 Identify Device Information Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 5.2 Error Posting Page Attribute Offset Data 7 6 5 4 3 2 1 0 Content Description CIS 2007 SanDisk Corporation 6-1 Rev. 12.0, 02/07 Function CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-2 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description Attribute Offset Data 7 6 5 4 3 2 1 0 Content Description CIS 2007 SanDisk Corporation 6-3 Rev. 12.0, 02/07 Function CIS Description SanDisk CompactFlash Card OEM Product Manual Attribute Offset Data 7 6 5 4 3 2 1 0 Content Description CIS 02/07, Rev. 12.0 6-4 2007 SanDisk Corporation Function SanDisk CompactFlash Card OEM Product Manual CIS Description Attribute Offset Data 7 6 5 4 3 2 1 0 Content Description CIS 2007 SanDisk Corporation 6-5 Rev. 12.0, 02/07 Function Configuration Index 0 CIS Description SanDisk CompactFlash Card OEM Product Manual Attribute Offset Data 7 6 5 4 3 2 1 0 Content Description CIS 02/07, Rev. 12.0 6-6 2007 SanDisk Corporation Function Interface Type SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-7 Rev. 12.0, 02/07 CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-8 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-9 Rev. 12.0, 02/07 CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-10 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-11 Rev. 12.0, 02/07 CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-12 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-13 Rev. 12.0, 02/07 CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-14 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-15 Rev. 12.0, 02/07 CIS Description SanDisk CompactFlash Card OEM Product Manual 02/07, Rev. 12.0 6-16 2007 SanDisk Corporation SanDisk CompactFlash Card OEM Product Manual CIS Description 2007 SanDisk Corporation 6-17 Rev. 12.0, 02/07 Page Appendix A Ordering Information A.1 SanDisk CompactFlash Memory Card 2007 SanDisk Corporation A-1 Rev. 12.0, 02/07 To order SanDisk products directly from SanDisk, call (408) 801-1000. Page Page Page C.1 SanDisk Corporation Policy