HOW TO ASSEMBLE
CAUTION: Completely assemble vacuum cleaner before using.
Handle styles may vary. One handle has four snap pins on the back side of the handle, the other handle has two snap pins on each side. The cord hooks may be different.
Assembly Packet
A - CONNECTOR
B - | C - | |
FASTENER | BOLT | SCREWS |
Step 1
Handle Connector
Push connector A into the upper handle and align holes. One connector, shown, is fl at on one side and the 4 pins snap into one side. The connector in Detail A has 2 snap pins on each side and alignment tabs that slide into the handle.
B
Step 2
FastenerA
Push fastener B into a hole and apply thumb pressure so fastener snaps into position. Secure second B fastener. Repeat steps 1 and 2
to complete the assembly of the handle. See Detail B.
E
C –
Tab
Detail A
Detail B
Step 3
Handle Socket
Push handle into handle socket E so handle grip curves away from the cleaner. Align the holes, insert the
Step 4
Outer Bag
Hold outer bag with zipper away from handle. Important:
To provide a good gasket seal, the bag coupling must seat firmly against the motor base and not overlap the furniture guard. Start the bag screws D by hand, then tighten
with a screwdriver.
Step 5
Bag Support
Loop the spring F onto the bag support G, located to the back of the upper cord hook.
G
Upper
Guide Upper Cord
Hook
F
E |
|
C– | Lower Cord |
| Hook |
D
Step 6
Cord Storage
Secure the cord in the guide below the upper cord hook as shown or secure the cord into the side of the upper cord hook.
Secure cord into lower cord hook. Pull up on cord to tighten but leave slack near the base so the cord does not strain when the handle is lowered for use. Wrap the cord around the cord hooks. Fasten the plug to the cord to prevent unwinding.
3