ROUTINE MAINTENANCE (continued)
Filter
Pre-Motor Filter
Check the
To Clean Pre-Motor Filter
1.Remove filter centered in the bottom of the bag compartment.
2.Shake filter to remove excess dust. If necessary, the filter can be cleaned by vacuuming with another cleaner or washing with mild detergent.
3.Reinstall filter after completely dry.
Use GENUINE EUREKA replacement
Models equipped with Cartridge Filter (Only cartridge style filters can be used with these models.) Check the True HEPA filter each time dust bag is changed. Replace twice a year or as needed.
True HEPA Cartridge
Latch
Filter Door Latch
To remove True HEPA cartridge filter
1.Push down on filter door latch and pull door away from cleaner.
2.Push down on HEPA cartridge latch and remove filter.
To replace True HEPA cartridge filter
1.Place bottom tabs of filter cartridge into slots. Rotate filter toward cleaner, press firmly against cleaner to latch. Make sure True HEPA cartridge latch is secured on both sides.
2.Replace filter door by placing tabs of door into slots on cleaner. Rotate door up and against cleaner until it locks into place.
NOTE: To have the benefit of a sealed True HEPA system, you must use one of the True HEPA cartridge filter systems.
Use GENUINE EUREKA replacement True HEPA Filter HF5, PN 61830 or Washable True HEPA Filter WHF5, PN 61840.
How To Clean Filters
1.Remove from cleaner.
2.To remove debris, tap filter against waste container or brush off. You may also vacuum the filter using a different cleaner. If filter needs further cleaning, wash under warm running water.
3.When all parts are completely dry, follow the above steps in reverse to reassemble.
NOTE: Do not put any parts in a dishwasher.
NOTE: Your washable filter may need to be replaced if cleaning it does not restore cleaning performance.
Be sure to use GENUINE EUREKA replacement filters.
PERIODIC MAINTENANCE
How To Change Light Bulb
(Only for models with a headlight)
NOTE: Turn off the power switch and disconnect the electrical cord before changing light bulb.
1.Lower handle. Remove the screw from lens cover.
2.Pull lens cover from cleaner.
3.Pull old light bulb out of socket.
4. Push new light bulb into socket.
5. Replace lens cover.
6. Secure with screw.
Use GENUINE EUREKA replacement light bulb, Part No.
9
