Sanyo AVM-2751S FRONT PANEL, REAR PANEL, REMOTE CONTROL, INSTALLING BATTERIES (2 AAA not included), Terminal (75 ohms), Cable / Antenna Input, Audio Output Jacks (Fixed)

FRONT PANEL

POWER

VIDEO IN L- AUDIO -R

MENU CH CH VOL VOL

Audio/Video Input Jacks (AV1) Connect external video equipment here (see page 8).

REAR PANEL

Audio/Video Input Jacks (AV2)		UHF/VHF/CATV
		75Ω
Connect external video equipment	AUDIO	AUDIO VIDEO INPUT
	OUTPUT	AV2
here (see page 9).
		VIDEO
Audio Output Jacks (Fixed)	L	L (MON0)
		AUDIO
Connect external audio
equipment here (see page 9).	R	R
		Cable / Antenna Input
		Terminal (75 ohms)

REMOTE CONTROL

INSTALLING BATTERIES (2 AAA not included)

1.Remove the battery cover by pressing the tab and tilting the cover upward. Insert batteries.

Make sure you match + / signs on the batteries with marks inside the remote control.

2. Replace battery cover. The remote control is ready!

Notes:

– Do not mix old batteries with new ones or mix different types of batteries together.

– Remove the batteries if the remote control will not be used for a month or more. Weak batteries may leak and cause damage.

QuickTips

■Make sure all cable connectors are fully seated on jacks.

See pages 8~9 before connecting external video equipment.

■Cables are not supplied for connect- ing your external equipment.

■A solid Blue screen with the word Video displayed means that the Video mode is selected, but no signal is being detected at the Video jack. Check connection, and turn on external equipment.

■Be sure batteries are installed correctly.

■Point the remote control toward the equipment you want to operate. Objects between the remote control and the equipment may cause misoperation of the remote control function.

IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed of properly in compliance with all applicable laws. For detailed information, contact your local County Solid Waste Authority.

5