8
General Operation
❒Off Timer
The OFF TIMER will switch off the TV automatical- ly after 30 minutes, 1 hour, 1 hour and 30 minutes, or 2 hours.
1 Press the TIMER button. | OFF 0:00 |
2 Press the VOLUME ( + or - ) button to select the time period.
■Just one minute before switching off the TV, “OFF 0:01” will be display on the screen.
■To cancel the OFF TIMER, select “OFF 0:00” by pressing the VOLUME (+ or - ) button.
■The OFF TIMER cancels when the TV set is turned off or if a power failure occurs.
❒On Timer
When the ON TIMER is set. TV will automatically be switched On to the selected programme position when the specified time has elapsed.
1 Press the TIMER button twice.
ON 0:00 2 | (ON TIMER setting mode) |
|
Programme position for when TV is switched ON by ON TIMER.
❒On Timer (Continued)
2 Press the VOLUME ( + or - ) button. The set time will be increased or decreased by 10 minutes each time the button is pressed ; the maximum time which can be set is 24 hours.
3 Use Direct Programme Selection to insert programme position for when TV is switched on by ON TIMER. (see page 7.)
■If no operation is performed after the TV has been switched on by the ON TIMER, such as if you are not at home, the TV will be automatically switched off after approximately 2 hours
■If the TV is already switched on when the time set for the ON TIMER has been reached, only the programme position will be changed to the set programme position.
■Cancelling ON TIMER. To cancel the ON TIMER, press the VOLUME ( + or - ) button to set it to “ON 0:00” while the ON TIMER screen is shown. Switching off the TV by pressing the Mains ON/OFF button will also cancel the ON TIMER settings.
❒Setting of the Colour System
Normally, set the colour system to “AUTO”, if the clear picture cannot be obtained even when the broadcasting or AV signal is received, press the RECALL/COLOUR SYSTEM button repeatedly until the optimum image can be produced.
(Refer to Broadcast Transmission System List indicated by the last of this page in a setup of Colour System.)
Each time the RECALL/COLOUR SYSTEM but- ton is pressed, colour system changes as follows;
6 | 6 |
AUTO | PAL |
6 | 6 |
NTSC4.43 | NTSC |
Note:Colour system is displayed according as Colour system option.
Colour and Sound System
❒Setting of the Sound System
To set the sound system, make it during
When the sound is not clear or no sound is pro- duced on a programme number position, select sound system repeatedly until the optimum sound is obtained.
(Refer to Broadcast Transmission System List indicated by the last of this page in a setup of Sound System.)
To select sound system:
■Press the SOUND SYSTEM button to select the sound system directly. The sound system will be memorized automatically.
or:
1)Select “SIF” with the Programme UP or DOWN button in the
