Sanyo Power Supply, CAR KIT ADAPTER FOR CDP-244CRONLY, Dc In, Note On Alkaline Batteries

Models: CDP-244 CDP-244CRB

1 9
Download 9 pages 63.4 Kb
Page 3
Image 3
POWER SUPPLY

POWER SUPPLY

CAR KIT ADAPTER (FOR CDP-244CR ONLY)

Plug one end of the AC adapter into the DC 4.5V jack, then plug the other end into an AC wall outlet.

NOTE ON ALKALINE BATTERIES

￿ When replacing the alkaline batteries,

use two new batteries of the same

type. Do not mix a used battery with a

new one or mix different types of

batteries.

￿ When inserting the batteries,

￿The supplied cigarette lighter adapter is designed for use with vehicles that have a 12V, negative ground electrical system.

￿Most vehicles have this type of electrical system, but if you are unsure about the system in your vehicle, contact the vehicle dealer.

Precautions on using the AC Adapter.

￿Do not touch the AC adapter with wet hands. Doing so is dangerous, as this could result in an electrical shock.

￿If the AC adapter is connected when the batteries are installed, the power supply automatically switches to the AC power source and the batteries are disconnected.

ALKALINE BATTERY INSTALLATION

Insert two AA batteries (not supplied) into the battery compartment on the bottom of the unit. Be sure to observe the proper polarity (the"+" and" - " signs) as indicated inside the battery compartment.

mistakenly inserting even one with

improper polarity will cause leakage.

￿ Never charge, heat, disassemble, or

throw batteries into a fire.

REMEMBER

￿ If the symbol " CAR KIT ADAPTER (FOR CDP-244CR ONLY) " flashes in the display, your batteries are weak. Replace them or use the AC adapter or cigarette lighter adapter (CDP-244CRB only).

￿ If the display is blank no numbers

show when PLAY/PAUSE button NOTE ON ALKALINE BATTERIESPrecautions on using the AC Adapter.ALKALINE BATTERY INSTALLATION is pushed, the batteries are dead. Replace them, or use AC adapter. (Also check if you inserted the batteries according to the + and - as

IMPORTANT NOTE:

Spent or discharged batteries must be recycled or disposed of properly in compliance with all applicable laws. For detailed information, contact your local solid waste authority.

CIGARETTE LIGHTER ADAPTER (FOR CDP-244CRB)

Plug one end of the cigarette lighter adapter into the [DC IN 4.5V], then plug the other end into the cigarette lighter jack.

DC IN 4.5V

Caution on the cigarette lighter adapter.

￿Use this unit only with the supplied cigarette lighter adapter. Use with other cigarette lighter adapters could damage the unit.

￿When the inside of the cigarette lighter jack is dirty with ashes or dust, the plug section may become hot due to poor contact. Be sure to clean the cigarette lighter jack before use.

￿After use, disconnect the cigarette lighter adapter plugs from both this unit and the cigarette lighter jack.

￿The cigarette lighter adapter may cause interference with reception from the car radio or another radio inside the vehicle. If this is the case, disconnect the cigarette lighter adapter from the cigarette lighter jack, or use the radio at a distance from the cigarette lighter adapter.

4

5

Page 3
Image 3
Sanyo Power Supply, CAR KIT ADAPTER FOR CDP-244CRONLY, Dc In, Note On Alkaline Batteries, Alkaline Battery Installation