STAND REMOVAL AND WALL MOUNTING (OPTIONAL)
Tools Needed: Phillips screwdriver
IMPORTANT NOTE:
Place HDTV face down on a padded or cushioned flat surface to protect the screen and finish. Wall mounting of the HDTV must be performed by a skilled person.
DP19649DP26649
1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.
2Use the screws you removed when dettach- ing the stand to secure the HDTV to a wall mounting kit (not included.)
VESA standard interface: 100 x 100
Mounting screws measurements:
M4 (4mm) Diameter,
GETTING STARTED
Install batteries in the remote control
(2 “AA”, not included)
PRECAUTIONS
To ensure safe operation, please observe the following precautions:
•Replace both batteries at the same time. Do not use a new battery with a used battery.
•There’s a risk of explosion if a battery is replaced by an incorrect type.
•Do not expose the Remote Control unit to moisture or heat.
•Be sure to match the “+” and
Need help?
1Remove the four (4) screws securing the foot stand. CAUTION: Hold the stand firmly as you remove the last screw.
2Use the screws you removed when detach- ing the stand to secure the HDTV to a wall mounting kit (not included.)
VESA standard interface: 200 x 200
Mounting screws measurements:
M6 (6mm) Diameter,
ANTENNA CONNECTION FOR OFF-AIR SIGNALS OR CABLE
ANTENNA
ANALOG / DIGITAL
ANTENNA IN
CABLE
NOTE: The tuner in this HDTV can receive digital and analog off air signals from an antenna. It can also receive analog or ClearQAM cable channels from a direct Cable TV connection.
www.sanyoctv.com 
