GETTING STARTED (REQUIRED INITIAL SETUP)

1 Install batteries in remote control (2AA, not included).

PRECAUTIONS

To ensure safe operation, please observe the following precautions:

Replace both batteries at the same time. Do not use a new battery with a used battery.

Risk of explosion, if battery is replaced by an incorrect type.

Do not expose the Remote Control Unit to moisture or heat.

Match the “+” and “–” signs on the batteries with marks inside the remote control.

2 Connect Signal to the DTV’s Integrated Analog / Digital 75 ohm Antenna Input terminal.

RF ANTENNA

CABLE OR

OR

CABLE BOX OR SATELLITE BOX

THE TUNER IN THIS DTV CAN RECEIVE:

1.Digital and / or Analog Off-Air Signals from an RF antenna.

OR

2. Analog or ClearQAM cable channels.

Note:You must search for ClearQAM channels using the “Digital Cable Search” menu option.

ANALOG / DIGITAL

ANTENNA IN

DTV RIGHT SIDE (VIEWED FROM BACK)

OR

3. The output from a VCR or cable box.

Digital signals from a Set-top (STB) Box should be received through the Component jacks.

This DTV can receive ANY unscrambled RF signal being broadcast.

(CONTINUED ON NEXT PAGE.) 14