HOW TO USE YOUR MICROWAVE OVEN SAFELY (cont.)
Although your oven is provided with safety features, it is important to observe the following:
a)It is important not to defeat or tamper with safety interlocks.
b)Do not place any object between the oven face and the door or allow residue to accumulate on sealing surfaces. Wipe the sealing area frequently with a mild detergent, rinse and wipe dry. Never use abrasive powders or pads.
c)When opened, the door must not be subjected to strain, for example, a child hanging on an open door or any load which could cause the oven to fall forward and cause injury and damage the door. Do not operate the oven if it is damaged, until it has been repaired by a qualified person. It is particularly important that the oven door close proper- ly and that there is no damage to the:
i) Door (bent), ii) Hinges and Latches (broken or loosened), iii) Door seals and sealing surfaces.
d)The oven should not be adjusted or repaired by anyone except properly qualified service personnel.
CARE OF YOUR MICROWAVE OVEN
1.Disconnect the AC plug from the outlet before cleaning.
2.Keep the inside of the oven clean. When food spatters or spilled liquids adhere to oven walls, wipe with a damp cloth. Mild detergent may be used if the oven gets very dirty. The use of harsh detergent or abrasives is not recommended.
3.The outside oven surface should be cleaned with soap and water, rinsed and dried with a soft cloth. To pre- vent damage to the operating parts inside the oven, water should not be allowed to seep into the ventilation slots.
4.If the Control Panel becomes wet, clean with a soft, dry cloth. Do not use harsh detergents or abrasives on Control Panel.
5.If steam accumulates on both sides of the oven door, wipe with a soft cloth. This may occur when the micro- wave oven is operated under high humidity conditions and this is not an indication of a malfunction in the unit.
How to clean the exhaust opening
1.Remove the two plastic pins and take off the duct cover.
2.Wipe any spills and splashes on the surface of the exhaust opening with a mild detergent solution, rinse and wipe dry. Wash the duct cover in mild sudsy water, rinse and wipe dry.
3.To reassemble, place the duct cover in position and push in the pins firmly.
Duct Cover |
Plastic |
Pins |
5
