Notes
•When using a two-speaker installation, the Green, Green/Black, Violet, Violet/Black wires, which are used for a four-speaker installation, are not used. The ends of these wires must be covered with electrical tape to prevent them from shorting to the unit or the vehicle chassis.
•When using a two-speaker installation, set the FADER control to the center position.
•When fuse replacement is necessary remove
the blown fuse by using pliers. Then install the new 15 amp. fuse.
Fuse 15A
NG OK
Burnt
LINE OUT/CD CHANGER CONNECTIONS
•The unit has a built-in CD changer controller and line output terminals. You can use a compatible Sanyo CD changer and a separate amplifier to upgrade your system.
RCA Line-out Jacks
OUTPUT
FRONT REAR White
L (eft)
CD Changer
DIN Socket
R (ight)
Red
External
Amplifier
CD Changer
Rear Speaker | Front Speaker |
CD Changer DIN Socket
•Connect the 8-pin DIN cable, which is supplied with the compatible Sanyo CD changer, to the DIN socket on the back of the unit.
RCA Line-out Jacks (For Speakers)
•Connect a patch cable (not supplied) from the White (left channel) and Red (right channel) RCA line output jacks to the line input terminals of the external amplifier.