Sanyo PDG-DWL100 owner manual Serial Control Interface, Operation, Appendices

Appendices

Serial Control Interface

This projector provides a function to control and monitor the projector’s operations by using the RS-232C serial port.

Operation

1.Connect a RS-232C serial cross cable to SERVICE PORT on the projector and serial port on the PC.

2.Launch a communication software provided with PC and setup the communication condition as follows:

3.Type the command for controlling the projector and then enter the “Enter” key.

Example

When you want to change the input to Computer 2, Type ‘C’ ‘0’ ‘6’ ‘Enter’.

Baud rate	: 9600 bps
Parity check:	: none
Stop bit	: 1
Flow control	: none
Data bit	: 8

Note

•The default of the baud rate is set to 9600 bps.

•Enter with ASCII 64-byte capital characters and one-byte characters.

56

English