Sanyo PDG-DWL100 Appendices, Order Replacement Lamp, Lamp Handling Precautions, English

Models: PDG-DWL100

1 63
Download 63 pages 45.65 Kb
Page 48
Image 48
ORDER REPLACEMENT LAMP

Appendices

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a

projection lamp, give the following information to the dealer.

Model No. of your projector : PDG-DWL100

Replacement Lamp Type No. : POA-LMP138

(Service Parts No. CHSP8EM01GC01 or 610 346 4633)

■ Model No. of your projector : PDG-DWL100 LAMP HANDLING PRECAUTIONS

This projector uses a high-pressure lamp which must be handled carefully and properly.

Improper handling may result in accidents, injury, or create a fire hazard.

Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.

If the projector indicates that the lamp should be replaced, i.e., if the lamp life warning message appears, replace the lamp with a new one IMMEDIATELY after the projector has cooled down. (Follow carefully the instructions in the Lamp Re- placement section of this manual.) Continuous use of the lamp with showing the lamp life warning message may increase the risk of lamp explosion.

A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immedi-

ately. Contact an authorized service station for a checkup of the unit and replace- ment of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.

47

English

English

Page 48
Image 48
Sanyo Appendices, Order Replacement Lamp, Lamp Handling Precautions, Model No. of your projector PDG-DWL100, English