Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
TROUBLESHOOTING & REPAIR |
ON/OFF POWER SWITCH REMOVAL
(LATER CODES MAY HAVE TOGGLE SWITCH)
➂ ➃ ➄
➁ | ➅ |
0
1
➀ | ➆ |
|
➀ON/OFF POWER SWITCH KNOB
➁ SCREW (SECURING KNOB)
➂ FACE PLATE
➃SCREWS (SECURING FACE PLATE)
➄ SWITCH
➅ L1 & L2 LEADS
➆ T1 & T2 LEADS
FIGURE F.13-ON/OFF Power Switch Removal/Replacement
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
REMOVAL/REPLACEMENT PROCEDURE
1.Disconnect input power to the machine.
2.Perform the CAPACITOR DISCHARGE PROCEDURE.
3.Remove the Right Case Side Assembly by removing the sheet metal screws.
4.Remove the black ON/OFF Power Switch knob and plastic insert by unscrewing the small screw in the center of the knob. Remove from the shaft. See Figure F.13.
5.Remove the face plate by squeezing the two tabs together and sliding the plate off. See Figure F.13.
6.Loosen the four screws on the plastic frame. These screws go through the Case Front Assembly into the line switch. When the screws no longer engage the line switch, remove the line switch so it can be worked on.
7.Remove and save the electrical tape. The electrical tape will be
8.Remove leads T1, T2, L1, & L2.
9.Install new ON/OFF Power Switch in reverse order of removal. Be sure to
