Return to Section TOC

Return to Section TOC

Section TOC

Return to Master TOC

Return to Master TOC

Master TOC

TROUBLESHOOTING & REPAIR

F-50

TORCH HEAD REMOVAL/REPLACEMENT

 

 

 

4-PIN CONNECTOR

ELECTRODE LEAD

PILOT LEAD

PHILLIPS HEAD SCREW

HANDLE

SAFETY LEADS

BRASS COMPRESSION NUT

CABLE STRAIN RELIEF

 

ALIGNMENT HOLE

 

 

FIGURE F.18-Torch Head Removal/Replacement

Return to

Return to Master TOC

REMOVAL/REPLACEMENT PROCEDURE

NOTE: See Figure F.18.

1.Disconnect input power to the machine.

2.Perform the CAPACITOR DISCHARGE PROCEDURE.

3.Disconnect and remove the torch cable assembly from the bulkhead compartment.

a.Locate the torch cable access door on the Right Case Side Assembly of the machine.

b.Remove the one sheet metal screw on the left-hand side of the access door and swing open the door.

c.Test for a voltage across the stud marked WORK and the bulkhead connector (brass fitting). NO voltage should be present. If a voltage is present, STOP. Perform

Capacitor Discharge Test again. If no voltage is present, continue test procedure.

PRO-CUT 60

Page 91
Image 91
Lincoln Electric SVM104-A service manual Figure F.18-Torch Head Removal/Replacement