This Projector can automatically detect display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be detected by this projector. If this happens, the projector cannot reproduce a proper image and the image is recognized as a flickering picture, a
This projector has PC ADJUSTMENT function, to enable you to precisely adjust several parameters to match with the input signal format. The projector has eight independent memory areas where you can store the parameter you have set. This enables you to recall the setting for a specific computer whenever you need it.
1 Press the MENU button and the 
and press the SELECT button. Another dialog box "Where to reserve" Menu will appear.
2 In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 8." When memorizing the new computer parameter, select the Mode with the message of "Free" by pressing the POINT UP/DOWN buttons and SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored."
3 When the Mode is selected, Parameter adjustment dialog box
appears. Adjust the each item to match with your computer.
Total lines The number of the total vertical lines. Adjust the number to match your PC image.
Total dots The number of the total dots in one horizontal period. Adjust the number to match your PC image.
Horizontal Adjustment of the horizontal picture position. When the image is not centered on the screen, adjust this item.
Vertical Adjustment of the vertical picture position. When the image is not centered on the screen, adjust this item.
Clamp Adjustment of the clamp level. When the image has a dark bar(s), try this adjustment.
Height Adjusting the vertical height of the picture image.
Width |
| Adjusting the horizontal width of the picture image. |
|
|
|
4 When the parameter data adjustment finishes to be set, select "Stored" and press the SELECT button. "OK?" dialog box is displayed for confirmation.
Each of the keys operates as follow.
| Reset |
|
|
| It recall the parameter data that previously adjusted. | |
|
|
|
| Mode free |
| It clear the parameter data previously set the selected |
|
| Mode. |
|
| |
|
|
|
|
|
|
| Stored |
| It stores the parameters in the memory. |
|
| |
| Quit |
| It closes the PC ADJUST Menu. |
5 To select the Mode manually adjusted in PC ADJUSTMENT Menu, select the mode at the SYSTEM SELECT Menu. (Refer to page 24.)
When the Mode is selected, below dialog box appears.
This Mode has parameters being stored.
The Vacant Mode.
Manual set Computer Mode (1 to 8).
It closes the PC
ADJUSTMENT
Menu.
Move the arrow to
▲or ▼ and press SELECT button.
Press SELECT button at this item to adjust “Clamp,” “Height,” or “Width.”
25