Setting
45
Ceiling
When this function is "On ", the picture is top/b ottom
and left/right reversed. This function is used to project
the image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right
reversed. This function is used to project the image to
a rear projection screen.
Ceiling
Rear
Input search
This function detects the input signal automatically.
When finding a signal, the search will stop. Use the
Point ◄► buttons to select one of the following.
Off. . . . . Input search does not work.
On1. . . . Input search works when pressing the
COMPUTER button or VIDEO button on the
remote control.
On2.. . . Input search works under the situation
below.
• When turning on the projector with
pres sing th e P OWE R O N/STA ND- BY
button on the remote control.
• When pressing the COMPUTER button or
VIDEO button on the remote control.
• When missing the current input signal. *
Note:
• While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the
signal is switched.
• Only the input source selected at the last time can be detected.
• If any of the COMPUTER button or VIDEO button on the remote control is pressed while Input
search is on, Input search will stop and go back to the previous input signal.
*If the No show or Freeze function is active, cancel it
to activate the Input search. It is also unavailable when
On-Screen menu is displayed.
Terminal
The COMPUTER IN 2/MONITOR OUT terminal on the
back of the projector is switchable for computer input
or monitor output. (See page 9) Select Computer 2 or
Monitor out with the Point ◄► buttons.
Computer 2......computer input
Monitor out.......monitor output
Terminal function is not available when selecting
Computer 2 to the input source. Change the input
source to the others (Computer 1 or Video) so that the
Terminal function will be available.(p.25, 34, 35)