Setting
47
Remote control
This pro jector provides two different remot e cont rol
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control interference when operating
several projectors or video equipment at the same
time.
When ope rating the p rojector in "Code 2", bo th the
projector and the remote control must be switched to
"Code 2".
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both th e MENU and I MAGE butt ons
together for 5 seconds or more. After changing the
code, make sure the remote control operates properly.
Remote control
Press and hold
MENU and
IMAGE buttons
for more than 5
seconds.
On start
When this function is "On", the projector is
automatically turned on just by connecting the AC
power cord to a wall outlet.
Note:
Be sure to turn the projector off properly (see
"Turning Off the Projector" on page 19). If the
projector is turned off in the incorrect sequence,
the On start function does not operate properly.
Lamp control
On start
This function allows you to change brightness of the
screen.
High.........Brighter than the Normal mode.
Normal.....Normal brightness.
Auto.........Brightness according with the input signal.
Note:
If the batteries are removed from the remote
control for a long period of time, the remote control
code will be reset.