Sanyo PLCSW20AR owner manual Remote Control Batteries Installation

BEFORE OPERATION

KEYSTONE BUTTON

Used to correct keystone distortion. (P20, 35)

D.ZOOM BUTTON

Used to select DIGITAL ZOOM +/– mode and resize image. (P29)

ON-OFF

KEYSTONE D.ZOOM VOLUME

LOCK

MUTEINPUT

MENU

VOLUME BUTTON

Used to adjust volume. (P21)

INPUT BUTTON

Used to select input source. (P22, 30)

Operating Range

Point Remote Control Unit toward projector (Receiver Window) whenever pressing any button. Maximum operating range for Remote Control Unit is about 16.4’ (5m) and 60° in front and rear of the projector.

MUTE BUTTON

Used to mute sound.(P21)

NO SHOW BUTTON

Used to turn the picture into black image. (P21)

AUTO PC ADJ. BUTTON

Used to operate AUTO PC Adjustment function. (P24)

LASER
NO SHOW	FREEZE
AUTO PC ADJ.	IMAGE
P-TIMER

FREEZE BUTTON

Used to freeze the picture. (P20)

IMAGE BUTTON

Used to select image level. (P27, 32)

16.4’

(5 m)

60°

REMOTE CONTROL BATTERIES INSTALLATION

1	Remove the battery
	compartment lid.

Press the lid down- ward and slide it.

2	Slide the batteries into	3	Replace the compartment
	the compartment.		lid.

Two AA size batteries For correct polarity (+ and –), be sure the battery terminals are in contact with the pins in the compartment.

To insure safe operation, please observe the following precautions :

●Use (2) AA, UM3 or R06 type alkaline batteries.

●Replace both batteries at the same time.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose Remote Control Unit to moisture, or heat.

●Do not drop Remote Control Unit.

●If a battery has leaked on Remote Control Unit, carefully wipe the case clean and load new batteries.

●Danger of explosion if battery is incorrectly replaced.

●Dispose of used batteries according to battery manufacturer's instructions and local rules.

15