APPENDIX
LAMP REPLACEMENT
LAMP REPLACE
When the life of Projection Lamp of this projector draws to an end, LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly.
This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly.
TOP CONTROL
WARNING
TEMP .
LAMP
REPLACE
| CAUTION |
Allow a projector to cool, for at least 45 minutes before | For continued safety, replace with a lamp assembly of |
you open Lamp Cover. The inside of a projector can | the same type. |
become very hot. | Do not drop a lamp assembly or touch a glass bulb! The |
| glass can shatter and may cause injury. |
Follow these steps to replace the lamp assembly.
1 | Turn off the projector and disconnect AC plug. Allow the |
| projector to cool at least for 45 minutes. |
2 | To remove Lamp Cover, remove the screw with a screwdriver . |
3 | Remove 2 screws with a screwdriver and pull out Lamp |
| Assembly by grasping Handle. |
4 | Replace Lamp Assembly with a new one and tighten 2 screws |
| back into position. Make sure that Lamp Assembly is set |
| properly. Replace Lamp Cover and tighten the screw. |
5 | Connect the AC Power Cord to the projector and turn on the |
| projector. |
6 | Reset the Lamp Replace Counter. |
| Refer to “LAMP REPLACE COUNTER” on the next page . |
NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced.
SCREW
LAMP COVER
HANDLE
LAMP ASSEMBLY
SCREW
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer.
● | Model No. of your projector | : | |
● | Replacement Lamp Type No. | : | |
|
|
| (Service Parts No. 610 295 5712) |
37
