Installation

1

Connect the computer's monitor output

 

terminal to the projector's input terminal with a

 

computer cable.

2

 

Connect the Presentation Remote Receiver to

 

the USB port of your computer.

3

 

Install the batteries into the Remote Control by

 

following the instructions below.

✔Note:

•The Presentation Remote Receiver can be connected to a standard USB port only.

•Some computer settings may have to be changed in order for the mouse function to be used. Refer to your computer's owner's manual for details.

•When switching the remote control code of the projector and the remote control, that of the presentation remote control also needs to be switched. To switch the code, press and hold both the MENU and IMAGE buttons for more than 10 seconds. (For details, refer to the owner's manual of the projector.)

Presentation

Remote Control

Computer cable Presentation

Remote Receiver

30°

16.4’ (5 m)

Presentation Remote

30° Receiver and Projector’s

IR Receiver.

Remote Control Battery Installation

1

Open the battery
compartment lid.

2

Install new batteries

3

Replace the compartment
into the compartment.lid.

Two AAA size batteries

For correct polarity (+ and –), be sure battery terminals are in contact with pins in the compartment.

To insure safe operation, please observe the following precautions:●Use (2) AAA or LR03 type alkaline batteries.●Always replace batteries in sets.●Do not use a new battery with a used battery.●Avoid contact with water or liquid.●Do not expose the remote control to moisture or heat.●Do not drop the remote control.

●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

●Risk of explosion if battery is replaced by an incorrect type.●Dispose of used batteries according to the instructions.

2