INSTALLATION INSTRUCTIONS
RCS-KS2432AWD
■Parts supplied with remote controller
See Table 1.
■Remote controller installation guidelines
Installation location
• Mount the remote controller 1 to 1.5 meters off the |
floor where it can sense the average temperature of |
the room. |
• Do not mount the remote controller in a place |
exposed to direct sunlight or where it is exposed to |
outside air such as near a window. |
• Do not mount the remote controller behind a curtain |
or other object so that it is separated from the air cir- |
culation of the room. |
• Mount the remote controller inside the room being air |
conditioned. |
• The remote controller should be mounted on a wall or |
Table 1
No. | Supplied parts | Q’ty | |
| Remote |
| |
➀ | controller | 1 | |
|
| ||
| (comes with |
| |
| 200mm wire) |
| |
| Machine screws |
| |
➁ | M4 ⋅ | 25 | 2 |
|
| ||
| Tapping screws |
| |
➂ | M4 ⋅ | 25 |
|
|
| 2 | |
| Spacers |
| |
➃ |
|
| 2 |
No. | Supplied parts | Q’ty |
| Wire joints |
|
➄ |
| 6 |
| Harness |
|
➅ |
| 1 |
| Clamper |
|
➆ |
| 1 |
| Instruction manual |
|
➇ |
| 1 |
other surface vertically. |
Switching the room temperature sensor
Room temperature sensors are separately incorporated in both the indoor unit and the remote controller. Either sensor can be used to sense the room temperature. The indoor unit sensor is usually used.
If you wish the remote controller to sense the room tem- perature, press the SENSOR button with a ballpoint pen or tool with a small tip.
■How to install the remote controller
<NOTE 1> Do not twist the remote controller wire with the power cord, or run them in the same metal conduit, because this may cause a malfunction.
<NOTE 2> Install the remote controller away from all
sources of electrical noise.
<NOTE 3> Install a noise filter or take other appro- priate action if electrical noise affects the power supply circuit of the unit.
•Use an electric junction box (supplied locally) for embedded mounting of the remote controller. (See Fig. 1)
Note: Remote controller model name
| |
Remote controller |
|
Lead wires (3) | Wall |
|
Electric junction box (no cover)
Machine screws
M4 ⋅ 25 (2)
Fig. 1
85464359404000 © SANYO 2003
W
