OUTPUT TERMINALS
TAPE END OUT Terminal
XDuring recording, when the end of the tape is reached or when the tape counter reading indicates 1 hours 57 minutes or more, the output becomes 0V (Low).
XTo reset the output, press the STOP or EJECT button.
XDuring autorepeat recording, when the end of the tape is reached, the output becomes 0V (Low) for about 2 seconds only.
Tape end or 1H57M00S
Output reset
5V (H)
(Output impedance: 5.7 kΩ) 0V (L)
TAPE END OUT Terminal Output Setting
1Press the MENU button until the (SET UP 3) menu is displayed.
@@@@@@@<SET@UP@3>
*ALARM@MODE@@@@@@@Y1
*ALARM@DURATION@@@20S
*TAPE@IN@MODE@@@@@STOP
*TAPE@END@MODE@@@@REW
2Press the * (or +) button, until the “TAPE END OUT” setting is flashing.
3Press the l (or j) button, to select the desired output mode.
END . . . . . . . The output becomes 0 V (Low) when the tape reaches the end.
4Press the SEARCH/AUDIO ON button to save the setting.
SW OUT Terminal
When recording, a pulse signal is output at the SW OUT terminal.
This terminal is usually connected to the switch input (SW IN) of devices like a camera switcher unit, or a quad compressor.
FIELD : 16.7 msec. FRAME : 5 msec.
5V (H)
(Output impedance: 5.7 kΩ) 0V (L)
SW OUT Terminal Output Setting
1Press the MENU button until the (SET UP 4) menu is displayed.
øThe FIELD (or FRAME) setting is flashing.
@@@@@@@<SET@UP@4>
*SW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@2H@@@@@@@@@@@@Y
*THREAD@CHECK@@@Y
*VIDEO@LOSS@@@@@N
*REC@SPEED@@@@@@N
NOTE:
XIf “TIMING” is set to FRAME (see step 4), “FRAME” will be indicated instead of “FIELD”.
2Press the l (or j) button to set the desired pulse signal interval.
Available settings are:
FIELD. . . . . . 01, 02, 03, 04, 05, 10, 30 or 60 field FRAME . . . . 01, 02, 03, 04, 05, 10, 30 or 60 frame
3Press the * button, until the “TIMING” setting is flashing.
4Press the l (or j) button to set “FIELD” or “FRAME”.
FIELD . . . . . . 1 pulse is output after each set number of fields.
FRAME . . . . 1 pulse is output after each set number of frames.
5Press the * button, until the “2H” setting is flashing.
6Press the l (or j) button to set the desired “2H” mode.
Y. . . . . . . . . . When recording in
N. . . . . . . . . When recording in
7Press the SEARCH/AUDIO ON button to save the settings.
English | 33 |