PARTS NAMES

8Lens iris output connector (4 pin)

This 4-pin connector is used to send the DC control signal and power supply to an auto-iris type lens.

9Camera setup section (under the cover)

This unit factory settings are as indicated below. These settings are for when using a 1/2 inch CS mount DC (without EE internal amplifier) type lens. However, if due to installation conditions or environment the settings may need to be modified for best results (see "SETTINGS"). To access the controls, remove the cover fixing screw, then remove the cover.

 

Control namePosition

 

 

 

a

High speed electronic shutter

All OFF: 1/60 sec

 

switches (E.S.)

 

 

 

 

b

Electronic iris (EI)/OFF

 

Backlight compensation (BLC)

 

 

switch

 

 

 

 

c