Sanyo VCB-9124 SETTINGS AND ADJUSTMENTS, Factory settings, Backlight compensation setting, BLC, LEVEL, A B C

SETTINGS AND ADJUSTMENTS

The digital process may disturb the image for about 5 seconds after the camera is turned on.

Factory settings

The camera is shipped from the factory with the following settings. These settings should give adequate results under normal conditions. If the settings need to be modified, please consult the reseller or installer.

A: BLC (backlight compensation) switch . . . . . . . . . . . .	. . . . . . . . 0 (OFF)
B: LEVEL volume control . . . . . . . . . . . . . . . . . . . .	All the way to the left
C: L-PHASE (line phase) volume control . . . . . . . . . . . . .	. . About the center

Backlight compensation setting

When the subject is backlit, set the BLC switch to 1 (ON).

The backlight compensation will measure the light in the center area of the image and the lens iris will be automatically set for optimum image quality. The subject contained in this area will be clear and bright.

•When the sides of the subject background are very bright, and the subject itself is dark.

☞In this case, the backlight compensation default setting may not give good results. To obtain a better image, set the BLC switch to 1 (ON), then turn the LEVEL volume control to the right until the desired correction level is obtained.

LEVEL

English 11

G

N

D

MONITOR

1

0

BLC

	A B C
			E
			S
1			A
			H
		P
		-
0		L
		LEVEL
	BLC