PARTS NAMES AND FUNCTIONS

1 Camera unit fixing screws (4)

These screws are used to attach the camera unit to the base. Tighten the four screws evenly when attaching the camera unit.

2 Screw openings for base installation

These openings are to attach the base to the ceiling or a wall using the four supplied tapping screws.

3 CAMERA (VIDEO) OUT terminal screw

Video signal output terminal. Insert the center wire of the coaxial cable into the CAMERA OUT terminal, then tighten the screw to secure it.

4 GND (ground) terminal screw

Video signal ground terminal. Insert the shielding mesh of the coaxial cable under the GND terminal plate, then tighten the screw to secure it.

5 Cabling tab

When the cables cannot be run behind the ceiling, etc., remove

this tab to allow the coaxial cable to go through.

6 24 V AC input terminal(24 V AC, GND)

With this camera use only the 24 V AC power adaptor model No. VPT-115available from Sanyo.

Power supply connections

Use a 3 wire grounded cable (22 AWG or more), and connect as shown by the illustration.

CAUTION:

•To prevent camera and/or AC adaptor failure, pay close attention polarity when making the connections.

•To prevent fire hazard any UL listed wire rated VW-1, should be used for the 24 V AC cable input terminal.

 

GND

AC

AC

 

7 Lens cover

This cover will protect the lens from dust and damage. Turn the cover in the direction of the arrow, shown on the illustration, to remove it. To install the cover, align the tabs (A) with the openings, then turn it in the opposite direction.

English 5