(A)1

4

DC

3

 

VIDEO

L

2

Installation of a DC type lens (sold separately)

1/3 inch CS mount type (Flange-back: 12.5 mm)

1Remove the lens mount cap.

2Install the auto-iris lens onto the camera.

Sanyo auto-iris lenses (sold separately)

•VCL-CS8LY: Standard angle, f= 8 mm

•VCL-CS4LY: Wide angle, f= 4 mm

•VCL-CS2LY: Ultra-wide angle, f= 2.8 mm

CAUTION:

Do not use a lens if the length “L” is more than 5 mm. That may damage the camera and prevent proper installation.

3Connect the lens plug to the LENS connector on the side of the camera.

When using lenses from other makers, make sure that the pins connections in the plug correspond to the ones of the camera.

Refer to the lens specifications to check the pins connections in the plug. If they are different from the ones indicated in the diagram, remove the original plug and connect the supplied plug according to the connections indicated by the diagram.

(For VIDEO type lenses, please refer to page 7.)

LENS connector layout (A)

1: Brake coil (–)

2: Brake coil (+)

3: Drive coil (+)

4: Drive coil (–)

2 1 2 1

4 3 4 3

4Set the A.I. LENS switch to the DC position.

The factory default setting is DC.

6 English