Sanyo VCC-3912 SETTINGS, A:Flange-backadjustment, B: Lens iris adjustment, LEVEL, B: Lens Iris, (See page 11), H (clockwise):, FLANGE BACK LOCK, electronic shutter

SETTINGS

The switches setting illustrated are the factory default settings.

F: High speed				D: Electronic iris (See page 11)
electronic shutter				E: Backlight compensation
setting (See page 12)					(See page 11)
					B: Lens Iris
	ON		E	A	EL VR401
	ON		S	EI	V
ON				EI	E
ON					E
OFF	1 2 3	4			L
OFF	1 2 3	4		ON	L H
F	R	B	W	OFF	DC
L			B	ON	VIDEO
				M BLC	A. I.
					LENS
	VR403 VR402
				C: White balance (See page 11)

A:Flange-back adjustment	B: Lens iris adjustment

If the pick-up surface is not correctly positioned with relation to the lens focal point, the picture will be out of focus (in particular when using auto-iris power zoom lenses, sold separately). If that is the case, adjust the flange-back position as described below.

1Using a + screwdriver, loosen the FLANGE BACK LOCK screw (M2:+).

2Set the zoom lens to the maximum telephoto position, set the focus using the focus ring on the lens.

3Set the zoom lens to the maximum wide angle position, set the focus using the FLANGE BACK ADJ. screw.

4Repeat steps 2 and 3, until the image stays in focus when changing from a telephoto shot to a wide angle shot.

When the setting is complete, tighten the FLANGE BACK LOCK screw.

If using a DC type auto-iris lens, you will need to set the LEVEL (VR401) volume when shooting in the conditions described below.

L (counterclockwise): To decrease the contrast

H (clockwise): To increase the contrast

EL VR401

•If shooting simultaneously in a dark room and through a bright window.

•If the subject background is extremely bright or dark.

•If the brightness of the picture on the monitor is not correct.

1 3

10 English

SETTINGS

A:Flange-back adjustment

B: Lens iris adjustment