Sanyo VCC-4115P INT, MANU, ATW, ATW:, CAUTION:, auto white, LL) position, Set the switch, ■ Line phase adjustment, ■ White balance adjustment

Adjust the LinePHASE volume on camera 2 until the vertical roll of the image stops.

If more than two cameras are used, please repeat this procedure for all the cameras.

INT

1 Set the switch6 to theLL) position.up (

2 Switch the display on the monitor from camera 1 to camera 2.

SETTINGS

■ White balance adjustment 5

■ Line phase adjustment 6

Normally the5 iswitchsettoATW:theauto whitedown (When using a camera switcher to c

balance) position and the white balance is adjustedto one monitor, there may be a ver

automatically. If a manual white balance adjustment is switched. In such a case, set as necessary, follow the steps below.

Set the switch5 to theMANU)upposition,( then adjust the colour.

• Turn R to set the red ratio and/orB to set the blue ratio.

MANU

R WB B

ATW

CAUTION:

If the vertical roll cannot be corrected by setting the Line PHASE volume on camera 2, try setting the LinePHASE volume on camera 1. If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct.

English 11