Installation

1.Installing the power board unit

1 Place the supplied pattern sheet on the ceiling, mark the locations and drill the holes for the cables and screws.

¥Pull out the cables from the ceiling.

Ceiling

Pattern sheet (Accessory)

2Attach the supplied dust sheet (A) to the base of the power board unit and the detachable piece of the sheet (B) to the side.

■When routing cables through side face of powerboard unit

A

3Pass the cables through the slit (C) in the dust sheet.

4Fix the power board unit to the ceiling using commercially available screws (4 places).

Make sure to tighten the screws properly. Using screws of sizes other than specified may cause the unit to fall.

Screw size (equivalent to M4/No.8)

 

¥ Nominal length: 40 mm (1.6 in) or more

B

¥ Head diameter: ¿8.3 mm (0.3 in)

5Connect the cables and set the switches (D).

ÒConnectionsÓ (Page 5), ÒControl/Address Settings (Page 9)Ó

C A

B

3C

4

D

5

3