Saturation, Metering, Capture Md, Quick Shot

Saturation

This sets the saturation of the image that will be captured. * High / Standard / Low

* Center:	Averages the light metered from the entire frame, but gives greater
	weight to the subject matter at the center.
* Spot:	A very small portion of the center of the screen is measured to calculate
	the correct exposure.
* Average:	The exposure is measured all of the image area.

This sets the recording method at the time of capturing images.

* Single:	Captures one image at a time.
* Continuous:	Permits continuous capture of up to 3 images.
* AEB:	Permits 3 consecutive images in the order of standard exposure,
	underexposure and overexposure compensation.
* Burst:	Permits continuous photography while pressing and holding the shutter
	button. As long as you hold the shutter button pressed, images are
	captured until the memory capacity is exhausted.
* Cont. flash:	Permits continuous capture of up to 3 images with flash.
* Pre-shot:	Select a background by 1st shot, the image shown on display will be
	transparent, then take the 2nd shot on the basis of 1st image. Image of
	1st shot is only a guiding tool, it won't be saved on SD card. Normally this
	function is used when taking a portrait picture and the background is
	selected by the model instead of the photographer.
* Coupl.shot:	Uses separate areas to combine two shots. You can include yourself in
	the shot.

If this function is set to “On”, the camera takes a quick shot without focusing.

* On / Off

This sets whether or not to use digital zoom at the time of photography.

* On / Off

The date of recording can be printed directly on the still images. This function must be activated before the image is captured.

* On / Off

Refer to the section in this manual titled “Setup Menu” for further details.