Cisco Systems 3560-X, 3750-X manual StackPower Cabling Configurations

Chapter 2 Switch Installation

StackPower Cabling Configurations

For general concepts and management procedures for switch power stacks, see the switch software configuration guide on Cisco.com.

Before connecting the switches in a power stack, keep in mind these guidelines:

•A switch power stack can include a maximum of four switches in a ring topology and nine switches in a star topology with the XPS-2200.

•Size of the switch and any optional power supply module. The 1100-W power-supply module is 1.5 inches longer than the other modules, and with the attached cable retention clip, it extends

3 inches from the switch chassis. Stacking switches with the same power-supply modules together makes it easier to cable the switches. For switch dimensions, see Appendix A, “Technical Specifications.”

•Length of cable. Depending on the configurations that you have, you might need different-sized cables. If you do not specify the length of the StackPower cable, the 0.3 meter cable is supplied. If you need the 1.5 meter cable, you can order it from your Cisco supplier. For cable part numbers, see the “StackPower Connector (Catalyst 3750-X Switches)” section on page 1-20. The “StackPower Cabling Configurations” section on page 2-9provides examples of recommended configurations.

•For rack-mounted switch stacks that are members of a data stack and a StackPower stack, see the “Switch Data Stacking Guidelines” section on page 2-5.

•For rack-mounted switch stacks connected to the XPS-2200, review this recommended sequence of events:

–If you are using the XPS-2200, first install the XPS at the bottom of the stack. If needed, allow one RU space between the XPS and the first switch above to provide room for cabling.

–Connect all the 12-pin XPS cables to the XPS-2200 as needed.

–Rack-mount the switches. If you have the optional 1100-W power-supply module, first rack-mount the switch before installing the power-supply module.

–Connect the XPS cable to the first switch above the XPS-2200. Connect the stack cables to the first switch above the XPS.

–Connect the XPS cable to the second switch above the XPS-2200. Connect the stack cables to the second switch above the XPS.

–Repeat until all devices are connected.

StackPower Cabling Configurations

This section describes the recommended cabling configurations for a StackPower stack. There are two types of StackPower cables. The cable in Figure 2-8connects a Catalyst 3750-X switch to another 3750-X switch in a power stack or to an XPS-2200. The cable in Figure 2-9connects a Catalyst 3750-X or 3560-X switch to an XPS-2200.

Note All cable connectors are keyed and color-coded, as are the connections on the switches (See Figure 1-6and Figure 1-7 on page 1-15).

Both cable types are available in two lengths.

Catalyst 3750-X and 3560-X Switch Hardware Installation Guide

OL-19593-01 2-9