
Chapter 2 Switch Installation
Connecting to the StackPower Ports (Catalyst
Caution Removing and installing the StackWise cable can shorten its useful life. Do not remove and insert the cable more often than is absolutely necessary.
When you need to remove the StackWise cable from the connector, make sure to fully unscrew the correct screws. When the connectors are not being used, replace the dust covers.
Connecting to the StackPower Ports (Catalyst 3750-X Switches)
Before connecting the StackPower cables, review the “Planning a StackPower Stack (Catalyst
Follow these steps to connect the StackPower cable to the StackPower ports:
Step 1 Remove the dust covers from the StackPower cable connectors.
Step 2 Connect the end of the cable with a green stripe to either StackPower connector on the first switch. Align the connector correctly, and connect the cable to a StackPower port on the switch rear panel.
(Figure
Step 3 Connect the end of the cable with the yellow stripe to another Catalyst
Step 4
Figure 2-23 Connecting the StackPower Cable to a StackPower Port
AC OK
| |
C3KX | |
PS OK |
|
AC OK
253213
Caution Removing and installing the StackPower cable can shorten its useful life. Do not remove and insert the cable more often than necessary.
| Catalyst |