6
Removing the Pedestal Stand
1)
Carefully lay the front of the TV face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge of the surface.
Note: Extreme care should always be used
when removing the pedestal stand to avoid
damage to the LCD panel.
2)
Remove the four screws shown in the below diagram.
This will allow removal of the pedestal stand.
3) Once you have removed all four screws, holding
the pedestal stand in place, remove the pedestal
stand from the TV.
CAUTION: Always place the TV on the floor or a
sturdy, level, stable surface that can support the
weight of the unit. To secure the TV, use a sturdy strap
from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the
strap is tight, secure, and parallel to the floor.
Notes on moisture condensation
Moisture condensation damages the unit. Please
read the following carefully.
Moisture condensation occurs, for example, when
you pour a cold drink into a glass on a warm day and
drops of water form on the outside of the glass. In
the same way, moisture may condense on this unit’s
internal optical pick-up lens, one of the most crucial
internal parts of the unit.
Example of moisture
condensation!
Optical pickup
lens
Moisture condensation may occur in the following
situations:
• When you move the unit from a cold area to a warm
area.
• When you use the unit in a room in which the heat
was just turned on.
• When you use the unit in an area where cold air
from an air conditioner directly hits the unit.
• When you use the unit in a humid area.
It’s too
warm!
Never use the unit when moisture condensation may
occur.
Using the unit when moisture condensation exists
may damage discs and internal parts. Connect the
power cord of the unit to the wall outlet, turn on the
unit, remove the disc, and leave it for two or three
hours. After two or three hours, the unit will have
warmed up and evaporated any moisture. Leaving
the TV connected to the wall outlet will help prevent
moisture condensation in the unit.
Wall outlet
Wait!

19SLV411U

Four screws
VESA Mounting Pattern
24SLV411U VESA Mounting Pattern
32SLV411U VESA Mounting Pattern
Four screws
Four screws Hook
Sturdy strap
(as short as possible)