IN CASE OF DIFFICULTY
If you have difficulty operating this phone, try the suggestions below. If you still have trouble, call 1 800
If the phone doesn’t work at all, check these items first:
•Make sure the AC adapter is plugged in.
•Make sure the telephone line cord(s) is plugged firmly into the base unit and the modular telephone jack.
•Make sure the antenna is fully extended.
•If the LOW BATT light is on, the battery pack needs recharging. If the battery pack will not charge, replace it with Replacement Battery 3740.
•Make sure the battery pack is installed correctly.
•If you have dial pulse (rotary) service on your phone line, make sure the dial mode switch is set to PULSE.
If the above suggestions don’t solve the problem, try
1Disconnect the power to the base.
2Remove the handset battery pack.
3Wait a few minutes.
4Connect the power to the base.
5Insert the handset battery pack.
6Put the handset in the base to
If you hear noise or interference when using the phone.
•Make sure the base antenna is fully upright.
•You may be out of range. Move closer to the base.
•Press and release cto change to another of the 10 channels available. If the noise is exceptionally loud, move closer to the base before changing channels.
•Household appliances plugged into the same circuit as the base can sometimes cause interference. Try moving the appliance or the base to another outlet.
•The layout of your home or office might be limiting the operating range. Try moving the base to another location, preferably on an upper floor.
18
9002_book.1AT&T | 18 | 8/12/98, 4:09 PM |
